shared default String address()
shared default void close()
Closes the producer, this method should be called when the message producer is not used anymore.
shared default MessageProducer<T> deliveryOptions(DeliveryOptions options)
Update the delivery options of this producer.
shared actual default MessageProducer<T> drainHandler(Anything()? handler)
Set a drain handler on the stream. If the write queue is full, then the handler will be called when the write
queue is ready to accept buffers again. See Pump for an example of this being used.
The stream implementation defines when the drain handler, for example it could be when the queue size has been
maxSize / 2
shared actual default void end()
Closes the producer, calls close
shared actual default void end(T t)
Same as end but writes some data to the stream before ending.
shared actual default MessageProducer<T> exceptionHandler(Anything(Throwable)? handler)
Set an exception handler.
shared default MessageProducer<T> send(T message)
This method actually sends a message using the send semantic regardless this producer
is a sender or a publisher.
shared default MessageProducer<T> send<R>(T message, Anything(Throwable|Message<R?>) replyHandler)
Like send but specifying a
replyHandler that will be called if the recipient
subsequently replies to the message.
reply handler will be called when any reply from the recipient is received, may be
shared actual default MessageProducer<T> setWriteQueueMaxSize(Integer maxSize)
Set the maximum size of the write queue to
maxSize. You will still be able to write to the stream even
if there is more than
maxSize items in the write queue. This is used as an indicator by classes such as
Pump to provide flow control.
The value is defined by the implementation of the stream, e.g in bytes for a
, the number of Message
shared actual default MessageProducer<T> write(T data)
Write some data to the stream. The data is put on an internal write queue, and the write actually happens
asynchronously. To avoid running out of memory by putting too much on the write queue,
check the writeQueueFull method before writing. This is done automatically if using a Pump.
shared actual default Boolean writeQueueFull()
This will return
true if there are more bytes in the write queue than the value set using setWriteQueueMaxSize